• UHF: 30 channels
• VHF: 16 channels
• PLL synthesized
• True diversity
• Dual-squelch circuitry
• 100 Meter range
• 10 Simultaneous channels

We call our system True Mobility because it provides the freedom you should expect from a wireless system. With a conventional wireless system, your range of movement is limited by the potential for feedback in acoustical "hot spots". Some areas are so feedback prone you cannot go near them. Other areas allow only minimal gain before feedback occurs. Sabine’s True Mobility system includes our patented, industry standard FBX Feedback Exterminator. The FBX automatically kills feedback in setup and during the show, giving you a greatly increased area of feedback-free movement. Your mic finally will sound loud and clear, and you’ll get the mobility you were hoping for when you chose a wireless system.

Sabine’s True Mobility doesn’t stop with automatic feedback control. Conventional wireless systems require the added cost of outboard processors to maximize performance. Sabine offers a different approach: on-board processing at no extra cost, all dedicated to one microphone. We call this Targeted Input Processing. With Targeted Input Processing, no mic gets more processing than it needs, and every mic gets precise, targeted control perfectly suited to provide maximum performance. Each True Mobility Wireless Receiver comes with the all-digital Targeted Input Processing you need for maxi-mum performance, yet Sabine’s sys-tem costs no more than other far less powerful UHF or VHF systems.

SW30-R UHF Receiver

• Carrier Frequency Range: UHF Band 800-960 MHz
• Frequencies: 30 pre-programmed
• Oscillation Mode: PLL synthesized
• Receiving Mode: True diversity
• Sensitivity: 6 dBV at S/N over 70 dB
• Image Rejection: >63 dB
• Spurious Rejection: >76 dB
• Stability: +/- 0.005%
• Maximum Deviation: +/- 40 KHz
• Dynamic Range: >100 dB
• S/N Ratio: >95 dB (Typical)
• THD: <0.3%
• Squelch: Sabine two-stage
• Squelch Quieting: 6~30 dB
• Frequency Response: 50 Hz-18 KHz +/- 3 dB
• Battery Charger: Built-in dual slot
• Power Supply: 12-15 VDC/100-240 VAC 50-60 Hz
• Rack-Mountable case
• Working Range: 100 meters

SW16-R VHF Receiver

• Carrier Frequency Range: VHF Band 160-250 MHz
• Frequencies: 16 pre-programmed
• Oscillation Mode: PLL synthesized
• Receiving Mode: True diversity
• Stability: +/- 0.005%
• Sensitivity: 10 dBV at S/N over 80 dB
• Image Rejection: >63 dB
• Spurious Rejection: >76 dB
• Maximum Deviation: +/- 30 KHz
• S/N Ratio: >96 dB
• Dynamic Range: >100 dB
• THD: <0.3%
• Squelch: Sabine two-stage
• Squelch Quieting: 12~40 dB
• Frequency Response: 50 Hz-18 KHz +/- 3 dB
• Battery Charger: Built-in dual slot
• Power Supply: 12-15 VDC/100-240 VAC 50-60 Hz
• Rack-Mountable case
• Working Range: 100 meters

• Ten Independent digital filters per channel, controlled automatically from 20 Hz to 20 kHz.
• Filter depth: 3 dB steps from 0 dB to -40 dB
• Filter width: .1 or .2 octave*
• Resolution: 1Hz from 20 Hz to 20 kHz
• Time required to find feedback: typically 0.3 seconds @1 kHz

• Threshold: -30 dBv to 0 dBv
• Ratio: 1:1 through infinity
• Knee: soft
• Attack: 1-66 msec
• Release: 400 msec

• Automatically detects sibiliance frequencies
• Cut range: 0 to -30 dB